Power, Motor & Robotics Development Tools (193 items)

VOLT USB Li-Polymer Battery Charger Board. The VOLT battery charger is a smart, dual purpose board that can charge Li-Polymer batteries and another device. A Li-Polymer battery can be charged using...

Click board comes with the header strips soldered. RELAY click mikroBUS™. The Click accessory modules plug into the MikroBUS sockets in MikroElektronika microcontroller development boards. The RELA...

Click board comes with the header strips soldered. DC MOTOR click mikroBUS™. The Click accessory modules plug into the MikroBUS sockets in MikroElektronika microcontroller development boards. DC MO...

Click board comes with the header strips soldered. STEPPER click mikroBUS™. The Click accessory modules plug into the MikroBUS sockets in MikroElektronika microcontroller development boards. STEPPE...

BUCK click is a buck switching regulator that accepts a wide input voltage range of up to 40V and steps it down to 3.3V or 5V. The click carries the LT3976 40V, 5A, 2MHz step-down switching regulat...

clicker 2 for FT90x Development Board. The clicker 2 is a development board that integrates many MikroElektronika products for you to produce the best designs possible. The board features two mikro...

Click board comes with the header strips soldered. PWM click mikroBUS™. PWM click is a mikroBUS add-on board for controlling sixteen PWM (Pulse Width Modulation) outputs through a single I²C bus in...

Click board comes with the header strips soldered. Relay2 click mikroBUS™. Relay2 click is a mikroBUS add-on board for adding two solid state relays. It features two of the LCA717, Single-Pole, Nor...

Click board comes with the header strips soldered. DC Motor 2 click mikroBUS™. The DC Motor 2 click board helps you to control a full H-bridge driver by plugging into one of MikroElektronika's deve...

Click board comes with the header strips soldered. Stepper 2 click mikroBUS™. The Stepper 2 click is an add-on board that driver bipolar stepper motors in micro-stepping modes. The Allegro MicroSys...

Fan click carries an EMC2301 controller for powering and regulating the operation of 5V four-wire fans, which are commonly utilized as coolers in computers and other electronics. The controller sup...

Click board comes with the header strips soldered. HAPTIC click mikroBUS™. The Haptic click is an add-on board that driver ERM (Eccentric Rotating Mass) and LRA (Linear Resonant Actuator) vibration...

Click board comes with the header strips soldered. Charger click mikroBUS™. Charger click is a mikroBUS add-on board with a single-cell Li+ battery charge controller and a battery charge monitor. T...

Click board comes with the header strips soldered. Stepper 3 click mikroBUS™. The Stepper 3 click is an add-on board that driver unipolar stepper motors with precise controls. A high-voltage, high-...

Click board comes with the header strips soldered. DC Motor 3 click mikroBUS™. The DC Motor 3 Click is an add-on board that drives Direct Current (DC) motors. A Pulse Width Modulation (PWM) Sensorl...