Power, Motor & Robotics Development Tools (1,433 items)

Power Management Function = Uninterruptible Power Supply (UPS) For Use With = Power Supply Kit Classification = HAT Featured Device = Battery Kit Name = Development Kit

The DRV2605 from TI is a fancy little motor driver. Rather than controlling a stepper motor or DC motor, its designed specifically for controlling haptic motors - buzzers and vibration motors. Norm...

DESCRIPTION A Feather board without ambition is a Feather board without FeatherWings! This is the Non-Latching Mini Relay FeatherWing. It gives you power to control, and control over power. Put sim...

DESCRIPTION A Feather board without ambition is a Feather board without FeatherWings! This is the Latching Mini Relay FeatherWing. It gives you power to control, and control over power. Put simply,...

A Feather board without ambition is a Feather board without FeatherWings! This is the DC Motor + Stepper FeatherWing which will let you use 2 x bi-polar stepper motors or 4 x brushed DC motors (or ...

Power Management Function = DC-DC Converter Kit Classification = Converter Module Kit Name = DC-DC Buck Converter

Kit Classification = Module Kit Name = DC-DC Fast Charge Module

Power Management Function = Stepper Motor Driver Kit Name = Stepper Motor For Arduino

Pmod HB3 2A H-bridge Driver. The Pmod HB3 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Two external pins are provided for optional sensor feedback f...

Pmod CON3 Quad Servomotor Interface. The Pmod CON3 provides a standard 3-pin connector for up to four hobby servo motors. 4 x standard 3-pin hobby servomotor connectors System must supply 50Hz PWM ...

Pmod HB5 2A H-bridge Driver. The Pmod HB 5 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Functionally identical to the Pmod HB3, it differs in that t...

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.Dual H-Bridge capable...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD. Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the curre...

610mm length of 2.5mm polyvinyl tube. Should only be used to measure dry air pressure. Unsuitable for liquids. Pmod DPG1 Differential Pressure Gauge. The Pmod DPG 1 is a differential pressure gauge...

The Pmod SSR is a solid state relay that features IXYS CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) contin...