The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
This ProClip is designed for installation of GPS devices. Center mount, High. NOT for vehicles with factory navigation, ONLY for installation of smaller GPS devices. Please read all of the instructions and look at the pictures before attaching the ProClip. It is very important to place the ProClip in the exact same position as shown in the pictures.
1. Remove the coin shelf above the air vents. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the enclosed gap opener into the gap between the center console and the surrounding frame, to widen the gap. Peel off the adhesive tape covers on the ProClip.
2. Press/hook the angled edge on the upper part of the ProClip into the gap next to the gap opener. Pull out the gap opener.
3. Make sure that the notch in the lower part of the ProClip is aligned with the hole in the dashboard, adjust the position if needed. Press forward on the lower part of the ProClip so the notch snaps into place in the hole in the dashboard.
4. The ProClip is in place. |
