FTDI Chip UART USB A Male to Female Converter Cable / 7417076

FTDI Chip USB To MPSSE CableThe FTDI Chip 500mm USB to MPSSE cable contains a small internal electronic circuit board, utilising the FTDI FT232H. It is encapsulated into the USB connector at the end of the cable to handle all the USB signalling and protocols. The cable provides a fast and simple way to connect devices with 3.3VDC digital interfaces to the USB. The integrated FT232H device incorporates a command processor called the Multi-Protocol Synchronous Serial Engine (MPSSE). The purpose of the MPSSE command processor is to communicate with devices that use synchronous protocols (such as JTAG, SPI, or I2C) efficiently. The cable is terminated by ten individual wires with single pole connectors that can be interfaced to a male header.Features and BenefitsConnector A is male USB Connector B is female receptacle USB 2.0 Hi-speed (480Mbps) and full speed (12Mbps) compatible Maximum output current rating is 250mA at 3.3VDC on VCC 1kB receive and transmit buffers for high data throughput Adjustable receive buffer timeout Entire USB protocol handled on the chip – No USB-specific firmware programming required Fully assisted hardware or X-ON/ X-OFF software handshaking Low operating and USB suspend current low USB bandwidth consumption Support for USB suspend and resume Synchronous serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI, and I²C Transmit and receive LED drive signals UHCI/ OHCI/ EHCI host controller compatible USB bus powered USB type A connector for direct connection to a host or hub Operating temperature ranges between -40 and 85°CApplicationsAutomation systems Electronic devicesCertificationsANSI/ESD S20.20:2014 BS EN 61340-5-1:2007 FCC certified CE certified UL2464 approved