Schneider Electric Software Licence for Use with XPSMC Safety Switch / 464899

To connect XPS-MC to a PC for programming and diagnostic purposes: Laptop PC with 9 pin serial port: use RS 382-2645 and 544-490 Laptop PC with USB port: use RS 464-962 and RS 218-080. XPS MCWIN, Configuration Software. 30 certified safety functions are available with this software and they are easily assignable to the safety outputs. The safety functions have multiple combination possibilities and various starting conditions. The safety functions are certified in accordance with EN 954-1/ISO 13849-1 and IEC 61508. All 8 safety outputs are suitable for use in safety related parts of control systems conforming to category 4 of EN 954-1/ISO 13849-1 and each output can disconnect one of its safety circuits. The main safety functions are as follows:. Emergency stop monitoring, with or without time delay, 1 or 2-channel wiring Two-hand control (type III-C conforming to EN 574-1) Guard monitoring with 1 or 2 limit switches, with or without locking Guard monitoring for injection presses and blowing machines Coded magnetic switch monitoring Safety mat monitoring Light curtain monitoring, solid-state and relay output types Zero speed detection Dynamic monitoring of hydraulic valves on linear and eccentric presses Monitoring safety stop at top dead centre on eccentric press Safety time delays Muting function for light curtains Enabling switch monitoring, 2 or 3 contact Logic OR function Foot switch monitoring Chain shaft breakage monitoring Hydraulic and eccentric press monitoring Position selector