Development kit  (4,836 offers of 5,329,341 product items)

The STMicroelectronics AEK-LED-21DISM1 LED driver board is designed for high brightness automotive LED front lighting applications. It can control four LED strings through two embedded L99LD21 flex...

Manufacturer: MIKROE Kind of connector: mikroBUS connector Supply voltage: 3.3V DC Kit contents: prototype board Interface: I2C Size: S Type of accessories for development kits: Click board Kind of...

For Use With mikroLab/EasyStart/mikromedia Starter Development Kits Product Range - Accessory Type AnyNet 2G Click Board SVHC No SVHC (14-Jun-2023)

Xilinx Spartan-7 FPGA (XC7S25-1CSGA225C) 3,650 slices containing four 6-input LUTs and 8 flip-flops 1,620 Kbits of fast block RAM Three clock management tile, each with a phase-locked loop and mixe...

This lovely little shield is the best way to add a small, colorful and bright display to any project. We took our popular 1.8" TFT breakout board and remixed it into an Arduino shield complete with...

Manufacturer: MIKROE Kind of connector: mikroBUS connector Supply voltage: 5V DC;3.3V DC Kit contents: prototype board Interface: SPI Size: M Type of accessories for development kits: Click board K...

For Use With mikroLab/EasyStart/mikromedia Starter Development Kits Product Range - Accessory Type Microwave Click Board SVHC No SVHC (14-Jun-2023)

Supports up to 20V Output Pull-up Voltage –40°C to 125°C Operating Temperature Range Supports Wide Range of Stepper Motors, DC Motors, Relays, and Inductive Coils Low Output VOL of 0.4V (Typical) W...

We heard once that in the 4th millenium B.C. some guy asked the person who invented the wheel that question. The person who invented the wheel’s answer, we were told, was something like “well it’s ...

Attention! This product is sold up to the quantity available in stock. In case of larger orders, the amount will be replaced by the available quantity. Manufacturer: MIKROE Kind of connector: mikro...

1-Wire I2C click carries the DS28E17 1-Wire-to-I2C master bridge from Maxim Integrated. The click runs on a 3.3V power supply. It communicates with the target microcontroller over 1-Wire® protocol,...

V to Hz 2 click is a device that converts an analogue voltage input signal into a pulse wave signal of a certain frequency. It has a linear response, so applying a voltage in a range of 0 to 3.3V o...

Manufacturer: MIKROE Kind of connector: mikroBUS connector Supply voltage: 5V DC;3.3V DC Kit contents: prototype board Interface: SPI;PWM;GPIO Size: M Type of accessories for development kits: Clic...

7x10 Y click displays letters, numbers, and characters in a 7x5 font resolution. It carries a matrix of 70 yellow LEDs driven by a pair of 8-bit serial-in, parallel-out shift registers, a Darlingto...

No external sense resistor required, single package solution Reduced power loss: 0.6 mΩ internal conductor resistance on EX package 1.2 mΩ internal conductor resistance on LC package Economical low...