Industrial Networks (2,310 items)

This digital output module transmits control signals from the automation device to the connected actuators. All outputs are short-circuit-protected. Field and system levels are electrically isolated.

The digital output module provides 8 channels in a width of just 12mm (0.47in.). The connected load is switched via digital output from the control system. All outputs are short-circuit-protected. ...

The analog output module generates signals of a standard magnitude 4–20mA. The output signal is electrically isolated and transmitted with a resolution of 12 bits. Power is derived from the field s...

Item description: The analog output module generates signals of a standard magnitude 0–10V. The output signal is electrically isolated and transmitted with a resolution of 12 bits. The internal sys...

After the fieldbus node is assembled with the correct buscoupler and I/O modules, the end module is snapped onto the assembly. It completes the internal data circuit and ensures correct data flow.

The supply module provides the I/O modules with the corresponding supply potential. The maximum current at the supply module is 10A. When configuring the system, it must be ensured that this total ...

The supply module provides the I/O modules with the corresponding supply potential. The maximum current at the supply module is 10A. When configuring the system, it must be ensured that this total ...

The internal system supply module increases the current supply for the internal system by 2A. If the internal current consumption of all modules is higher than 2A, an additional supply module must ...

Bus Extension End Module The end module for the internal data bus extension 750-627 is attached to the end of the I/O terminal block like the standard end module 750-600. The block is terminated wi...

Bus Extension Coupler Module The coupler module for the internal data bus extension module 750-628 replaces the fieldbus coupler/controller at an I/O terminal block. It is also the mating piece for...

MP-Bus Master The 750-643 I/O module acts as a master for the MP bus (Multi Point Bus from Belimo/Switzerland) and allows the bus to be integrated into a higher level bus network such as Ethernet o...

The serial interface module connects RS‐485/422 or RS-232 C interface devices to the WAGO-I/O-SYSTEM 750. It also provides gateways between the serial interface and the fieldbus systems supported b...

The interface integrated in the I/O module allows the connection of any device which is equipped with an RS-485 interface. The interface operates in accordance with the TIA/EIA-485-A, DIN 66259 sta...