Test Probes (30 items)

Better than a test probe alone – these two inch long rigid back probe pins easily pass between the weather pack seal and wire. A sharp point ensures good contact to the electrical connector, and th...

Converts a BNC scope lead to a dual banana plug for connection to a DMM. Required when adapting a shielded BNC cable, found on high-end low current clamps such as the Fluke 80i-110s, to a DMM.

SureGrip accessories are designed to improve steadiness in slippery hands. Rubber over moulded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they...

Attach this small, rugged light to any Fluke test probe and see exactly what you are trying to probe.

Test leads are an integral part of the complete measurement system and extend the capabilities of your digital multimeter. The TL224 SureGrip™ Insulated Test leads offer reinforced strain relief an...

Keep your test and measurement accessories always available and untangled. This is the convenient way to store your coaxial cable assemblies, patch cords and test leads. Holders mount easily on any...

SureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they ...

SureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they ...

When you attach these probe extenders to your SureGrip test probes you will move your hands 12 inches from the contact point. A probe light is included to illuminate hard-to-see contact points.

SureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they ...