The RG174/RG179 Coloured Boot allows easy identification of cables by colour coding the strain relief boot. These boots also provide effective strain relief on the cable. Available Colours - Green,...
The RG174/RG179 Coloured Boot allows easy identification of cables by colour coding the strain relief boot. These boots also provide effective strain relief on the cable. Available Colours - Green,...
The RG58 Coloured Boot allows easy identification of cables by colour coding the strain relief boot. These boots also provide effective strain relief on the cable. Available Colours - Black, Blue, ...
The RG59 Coloured Boot allows easy identification of cables by colour coding the strain relief boot. These boots also provide effective strain relief on the cable. Available Colours - Black, Blue, ...
The RG59 Coloured Boot allows easy identification of cables by colour coding the strain relief boot. These boots also provide effective strain relief on the cable. Available Colours - Black, Blue, ...
Available in single (25mm x 50mm), dual (50mm x 50mm) and quad (100mm x 50mm) module sizes. Brush Modules are typically used in AV and similar applications to hide wires from view. They are intende...
A single gang 50 x 50 bevelled faceplate which will accept up to two 25mm x 50mm modules. If only one module is installed, the faceplate can be finished off by using a 25mm x 50mm blanks or present...
A single gang 50 x 50 flat faceplate which will accept up to two 25mm x 50mm modules. If only one module is installed, the faceplate can be finished off by using a 25mm x 50mm blanks or presenting ...
A single gang faceplate which will accept up to two 25mm x 50mm modules. If only one module is installed, the faceplate can be finished off by using a 25mm x 50mm blanks or presenting the module ce...
Cablenet white surface back boxes are manufactured in tough ABS which is less brittle than traditional electrical back boxes and so are less prone to damage during installation. Single gang (86mm x...
A double gang 50 x 100 flat faceplate which will accept up to four 50mm x 25mm modules. If the faceplate is not fully populated with modules, any gaps can be filled by using an appropriate number o...
High performance shielded connector suitable for termination of extra large outer diameter cables for Category 6 and Category 6A. Accepts cable diameter up to 8mm. 3 prong contacts accepts solid or...
This RJ45 adapter is used to run RS232/Serial data over longer distances using Cat5e cable to bridge the gap. Used in pairs and have selectable pin assignment to enable them to be used for a variet...
