Development Tool Accessories (47 items)

Reduced form factor ARM/Cortex Debug Probe, Microchip PIC32 Debug Probe, Renesas RX Debug Probe, and SiLabs EFM8 / C8051 Debug Probe. Includes a USB cable, and a 20-pin, 0.1″ ribbon cable. Addition...

J-Link ARM7/9/11 14-Pin Adapter. The J-Link 14-Pin Adapter allows J-Link to work with ARM7/9/11 target processors. It is not needed with most new evaluation boards. Supported Probes. • J-Link BASE ...

J-Link ARM SWD Isolator Board. The J-Link SWD Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin debug connector to provide electrical isolation. This is essential when...

The SEGGER SiFive-ARTY Adapter allows debug connections between J-Link and the ARTY board running SiFive RISC-V core bitstreams.The ARTY board provides several identical headers where the JD header...

The SEGGER J-Link Microchip 2-Wire JTAG TDI Adapter allows debug connections between J-Link and target hardware which comes with Microchip IS208x series MCUs. It supports the Microchip 6-pin single...

The SEGGER Flasher STM8 Adapter converts the standard J-Link 20-pin 0.1″ connector to the SWIM connector and a standard 10-pin connector. In addition the target board can be power using the externa...

SEGGER Microcontroller AdapterThe SEGGER Microcontroller adapter is J-Trace MICTOR 38 adapter that connects to the 38-pin MICTOR connector. It connects the GND, JTAG and some trace pins to their co...

The Flasher RL78 Adapter converts the standard J-Link 20-pin 0.1″ connector to the standard 14-pin E1 connector defined by Renesas. Please note that this adapter is usable only with the Flasher PRO...

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable

J-Link Target Supply Adapter. The J-Link Target Supply Adapter provides an adjustable power supply to a target board. Compatible Probes. Segger J-Link BASE Emulator ( ; 131-1319) 131-1319) , J-Link...

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable

The SEGGER J-Link 6-pin Needle Adapter has been designed to connect J-Link to a PCB which does not come with a mating connector or programming header.No additional connector required on your PCB Ve...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

The SEGGER J-Link Measurement+Patch Adapter provides test points for all debug signals to allow easy access for test probes. It has a standard 20-pin 0.1″ socket towards the J-Link debug probe and ...

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...