Power, Motor & Robotics Development Tools (7 items)

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.Dual H-Bridge capable...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD. Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the curre...

Pmod HB3 2A H-bridge Driver. The Pmod HB3 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Two external pins are provided for optional sensor feedback f...

Pmod CON3 Quad Servomotor Interface. The Pmod CON3 provides a standard 3-pin connector for up to four hobby servo motors. 4 x standard 3-pin hobby servomotor connectors System must supply 50Hz PWM ...

Pmod HB5 2A H-bridge Driver. The Pmod HB 5 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Functionally identical to the Pmod HB3, it differs in that t...

The Pmod SSR is a solid state relay that features IXYS CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) contin...

610mm length of 2.5mm polyvinyl tube. Should only be used to measure dry air pressure. Unsuitable for liquids. Pmod DPG1 Differential Pressure Gauge. The Pmod DPG 1 is a differential pressure gauge...