Power, Motor & Robotics Development Tools (12 items)

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.Dual H-Bridge capable...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD. Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the curre...

Pmod HB3 2A H-bridge Driver. The Pmod HB3 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Two external pins are provided for optional sensor feedback f...

Pmod CON3 Quad Servomotor Interface. The Pmod CON3 provides a standard 3-pin connector for up to four hobby servo motors. • 4 x standard 3-pin hobby servomotor connectors • System must supply 50Hz ...

Pmod HB5 2A H-bridge Driver. The Pmod HB 5 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Functionally identical to the Pmod HB3, it differs in that t...

610mm length of 2.5mm polyvinyl tube. Should only be used to measure dry air pressure. Unsuitable for liquids. Pmod DPG1 Differential Pressure Gauge. The Pmod DPG 1 is a differential pressure gauge...

For Use With = Vibrators Kit Classification = Module Kit Name = Half Wave Vibrators

For Use With = Vibrators Kit Classification = Module Kit Name = Half Wave Vibrators

For Use With = Vibrators Kit Classification = Module Kit Name = Half Wave Vibrators

The United Automation half wave vibrator controller. This single phase half wave controller with integral 10A device has been designed to operate on either 110V or 240V inputs. Its simple 2 wire co...

The United Automation half wave vibrator controller. This dual voltage half-wave vibrator controller can be set to operate at either 240V or 415Vac line voltage. The unit can be calibrated to accep...

The United Automation half wave vibrator controller. This single phase half wave controller with integral high current device, has been designed to operate on either 110V or 240Vac supplies. Its si...