Power, Motor & Robotics Development Tools (9 items)

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.Dual H-Bridge capable...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD. Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the curre...

Pmod HB3 2A H-bridge Driver. The Pmod HB3 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Two external pins are provided for optional sensor feedback f...

Pmod CON3 Quad Servomotor Interface. The Pmod CON3 provides a standard 3-pin connector for up to four hobby servo motors. • 4 x standard 3-pin hobby servomotor connectors • System must supply 50Hz ...

Pmod HB5 2A H-bridge Driver. The Pmod HB 5 features a full H-Bridge driver circuit for driving a brushed DC motor from the system board. Functionally identical to the Pmod HB3, it differs in that t...

610mm length of 2.5mm polyvinyl tube. Should only be used to measure dry air pressure. Unsuitable for liquids. Pmod DPG1 Differential Pressure Gauge. The Pmod DPG 1 is a differential pressure gauge...

Parallax Inc. Single Relay ModuleThe Parallax Inc. single relay board allows you to control high power devices (up to 10A) via an on-board relay. This module operates on a supply voltage rating of ...

Parallax screwdriver, USB-A to Mini-B cable. BASIC Stamp Boe-Bot mobile robot kit. Build your own mobile robot with a BASIC Stamp 2 microcontroller brain. Follow the clear, step-by-step instruction...

Parallax screwdriver. You will need an Arduino processor board (not supplied) such as an Arduino Uno, RS No: ; 715-4081 715-4081. Arduino BoE robotics Shield kit. Make your Arduino the on-board bra...