Signal Conditioners (167 items)

Module Type = Temperature Transducer Input Signal Type = Temperature Output Signal Type = Current Input Range = -20 → 100mV Output Range = 4 → 20mA Supply Voltage = 11 → 36V dc Series = MACX

Inverter module. The inverter module inverts the signals of ground switching n-p-n transistor outputs into plus switching p-n-p outputs, and vice versa.

Measuring transducer repeater power supply and input signal conditioner, HART-transparent. Transmits supplied or active 0/4…20 mA electrically isolated signals from the field to two loads. 4-way el...

Measuring transducer repeater power supply and input signal conditioner, HART-transparent. Transmits supplied or active 0/4…20 mA electrically isolated signals from the field to two loads. 4-way el...

Module Type = Temperature Transducer Input Signal Type = Voltage Output Signal Type = Relay Supply Voltage = 24/230V ac/dc

The Phoenix Contact MACX series have temperature measuring transducer with analog output and 1 limit value relay. This transducer have push in connection with 4 mA to 20 mA current output signal.Re...

The Phoenix Contact NAMUR signal conditioner with wide range power supply for proximity sensors and switches. It is used for line fault detection.Degree of pollution 2 Overvoltage category III Grey...

The Phoenix Contact NAMUR signal conditioner with wide range power supply for proximity sensors and switches. It is used for line fault detection.Degree of pollution 2 Overvoltage category III Grey...

The Phoenix Contact NAMUR isolating amplifier for operating proximity sensors and switches in Ex areas. The signals are transmitted via 2 relay outputs to the safe areas.Degree of pollution 2 Overv...

The Phoenix Contact NAMUR isolating amplifier for operating proximity sensors and switches in Ex areas. The signals are transmitted via 2 transistor outputs to the safe areas.Degree of pollution 2 ...

Ex i measuring transducer power supply and input signal conditioner, HART-transparent. Transfers supplied or active 0/4…20 mA electrical isolation signals from the Ex area to two loads in the safe ...

Repeater power supply for supplying 2 and 3-conductor transmitters with HART transmission and wide range power supply, SIL, Push-in connection

The Phoenix Contact repeater power supply and input isolating amplifier with push in connection and nominal voltage 24VD.Power supply possible via DIN rail connector Up to SIL 2 according to EN 615...

Ex i solenoid driver. For the intrinsically safe control of Ex i solenoid valves, alarm modules or LEDs installed in the Ex area. Current limitation at 25 mA. For gases up to Group IIC, loop-powere...

The Phoenix Contact MACX series have isolation amplifier for operating proximity sensors and switches in Ex areas. This isolation amplifier have 24 V dc nominal supply voltage with push in connecti...